Mechanical seal material weight calculation

Mechanical seal material calculation parameters

First, the density

1,2 Cr13, 1Cr18Ni9Ti, 1Cr18Ni12Mo2Ti Density 7.9kg / cm³ 2. YG6, YG8, YN6, YN8 Density 14.9kg / cm³ 3. Silicon carbide density 3.2kg / cm³ 4. Polytetrafluoroethylene 2.2kg / cm³ 2. Weight calculation Unit: kg, mm)

1, Yuan steel weight calculation coefficient: diameter 2 × 0.0000062 × length

2, stainless steel ring forging weight calculation factor: (diameter 2 - diameter 2) × 0.000006758 × length (including 7% of the fire)

3, the alloy ring weight calculation coefficient: (diameter 2 - diameter 2) × 0.0000117024 × length

Third, the standard machining allowance

1, when the product diameter smaller, thicker or longer wall thickness is not suitable for forging processing using direct processing yuan, the margin selected by the following principles:

(1) The product diameter ≤60mm, length ≤120mm: yuan steel outer diameter = product diameter + 1mm and then selected from the standard diameter of steel; such as product diameter Φ45 ~ Φ49mm select Φ50mm yuan steel. Blank length size = product length +4 ~ 5mm.

(2) 60mm

(3) 100mm

2, when the product requires forging or casting process due to process requirements, the margin should be selected according to the following principles:

(1) The diameter of the product ≤80mm: The diameter of the blank = size of the product + (-) 5mm (Note: the inner diameter adopts "-" the same below);

(3) 80mm

(4) 100mm

(5) 130mm

(6) 160mm

(7) 200mm

(8) 280mm

Attached: 1Cr18Ni12Mo2Ti inner diameter ≤ 40mm, 1Cr18Ni9Ti inner diameter ≤ 45mm, outer diameter ≤ 100mm 2Cr13 In principle, the use of direct processing yuan.

Fourth, material loss

1, forging fire consumption 7%; all plate cutting round calculation, cut the ring calculation board (such as cutting Φ200 × Φ100 ring count 200 × 200 plate).